Right-sized
Plenums, trunks, and branches built to match your unit's CFM and your home's load — not whatever was in the truck.
Custom Ductwork
We fabricate our own ductwork — on-site.
A new HVAC system is only as good as the ducts it pushes air through. We measure your house, cut and form the metal at the job, and put in tight, balanced runs that actually deliver the airflow your unit was sized for.
PHOTO: DUCTWORK FAB
tools / hand-formed metal
tools / hand-formed metal
Why fab on-site
Pre-made ducts fit a catalog. Custom ducts fit your house.
Off-the-shelf fittings force extra transitions, extra elbows, and extra leakage points. On-site fabrication means fewer joints, fewer surprises, and a system that runs at the static pressure it was designed for.
Sealed & insulated
Mastic-sealed joints, insulated runs in unconditioned space. You don't lose half your cool air on the way to the register.
Balanced airflow
Every room gets the temperature it should. No more "the back bedroom never gets cool."
Our process
How a custom duct job goes.
01
Measure & design
We walk the house, run a load calc, and plan the duct layout to match.
02
Fabricate on-site
Sheet-metal trunks, plenums, and fittings cut and formed at the job.
03
Install & seal
Mastic-sealed joints, properly supported runs, insulation where it belongs.
04
Test & balance
Static pressure checked, registers adjusted, every room verified before we leave.
Need ductwork done right?
New construction, remodel, or replacing tired old duct runs — we'll quote it free.